What #s do you think I will have/run? I have a 01 L and I just ordered,

Ported Eaton
4 LB Pully
FTVB
D. Tunner
Magna Flow Catback
Bassani High Flow Cats
Stage 2 Heads
12" Power Stack
Single Blade T.B.
C&L Plenum
58" Tracktion Bars
4.10 Gears

This will all be on in 2 weeks. I ran a 6.010 on a 330 FT. track so a 16th mile. Thats all I have near by. My mods then where 2 LB pully and some cheep chip... stock wheels and f1's. Anybody have sim. mods? What do you run 1/4?

 

ROB IS EXPERT ON SUCH MATTERS HE SHOULD CHIME IN BEFORE LONG

 

I say mid to high 12's. oh ya you might want to get some colder plugs too.

 

With a ported eaton, FTVB, 4#, K&N panel, and a SCT tune I ran 12.7@108. So I would expect you to be in the low 12's if you have good traction.

Mook

 

bad00

I say mid to high 12's. oh ya you might want to get some colder plugs too.

What mods do you have?

Cause I was hoping for at least low 12's

 

What plugs should I get and what gap should they have?

 

Definately a colder plug. Gapped at around 0.032".

I'd put you at a 12.2 assuming your running some tall slicks.

Rich

 

In my old 2001 I've gone 12.29 @ 110.55 with-
4lb, Cone Filter, Acc. T-body, E-Fan Kit, Muffler, LineMod Valve, Chip, 58"Bars, 28"Hoosiers.
This was in 30° dry air at Houston though which will make a big difference on the Lightnings.

 

Full exhaust, pi 2600 converter, 28" QTP's,caltrack's, 4lb lower, 2.8 upper, 90mm maf and open filter, 75 shot zex,D. Revolution chip, I have to get my truck on a dyno I think it running super safe on the spray. But it has stayed together for a lot of nitrous Passes So far I have a bunch of 12.0x passes

 

Not to put a damper on it, but you guys better look and see what his altitude is before making a guess. He may not have much air up there.

 

Tim, your email is timburntire at aol dot com right?

I sent something to that address but wanted to confirm it was yours.

 

Im at 5,000 ft.