SIlver Bullet Cat Back install help?
Thread Starter
|
Senior Member
Joined: Aug 2001
Posts: 789
Likes: 0
From: Leander TX
SIlver Bullet Cat Back install help?
(Did that search button thingy already on 4 boards)
The stock setup came off easy.
Currently it's sitting with pass. mide pipe loosened at the manifold, x-pipe/silver bullets are on (not tightened), the tail pipes slid in the mufflers and are hanging (not tightened).
With everything loose, I can not get the tips to line up in the side exit body panel. They are almost 3.0-3.5 inches too low.
The "Kooks-JDM-Eng." plate welded onto the X-pipe is facing towards the ground (went by the pics in the directions)
Any Ideas?
The stock setup came off easy.
Currently it's sitting with pass. mide pipe loosened at the manifold, x-pipe/silver bullets are on (not tightened), the tail pipes slid in the mufflers and are hanging (not tightened).
With everything loose, I can not get the tips to line up in the side exit body panel. They are almost 3.0-3.5 inches too low.
The "Kooks-JDM-Eng." plate welded onto the X-pipe is facing towards the ground (went by the pics in the directions)
Any Ideas?
