I was wondering if anybody has some pictures of a drive shaft loop installed, I'm thinking of just building my own. They can't be that expensive to build.

thanks

 

They are pretty easy to make. $30 (US) and a trip to the hardware store will set you up.

*ONLY* thing that might make it a bit complicated is the muffler. My spintechs are small and allowed for a simple 1.25" square tube that goes straight from one frame rail to the other. If your muffler hangs a bit below that plane (like a stock one) then you'll have to add a jog to the lower piece.

Otherwise it's pretty simple. I just took a wire and bent it into shape while positioning it 6" back from the tranny./yoke. Cut that shape into a 1" x 12". And bent the 0.1875" x 1.5" steel strap into that shape. Cut the ends and drilled all my holes.


Rich

 

I use Sal's (PSP) DS Loop HERE



Sorry, not alot to see, someday (now that I have a good Camera)
I have to take some new shots for my Gallery to replace the old

 

 

I made mine myself out of stainless flatbar @ work. What could be better, getting paid to make stuff for your truck



Even made a bracket for my PSP FastAir scoop to fit around the JDM/Fluidyne heat exchanger

 

Metco here...
You can see it just above my seperated X-Pipe:o