Clunk was not _the_ Clunk
Thread Starter
|
Senior Member
Joined: Nov 2003
Posts: 148
Likes: 0
From: Roswell, GA
Clunk was not _the_ Clunk
My mistake, but maybe it can can be helpfull to to others?
Had _a_ clunk sound so I bought a pair of Herbs washers from DL, and went under the truck to install them. Couldn't loosen the nut off the bolt from the rear left control arm, it was just to tight. So I figure hmmm... if it's that tight maybe that's not what's making the clunk. Looked around and thought the Rancho bars looked pretty easy to try and remove. Off they came and gone was the clunk sound
Turns out that the bar's rubber bushings need a good lube job before I put them back on
Had _a_ clunk sound so I bought a pair of Herbs washers from DL, and went under the truck to install them. Couldn't loosen the nut off the bolt from the rear left control arm, it was just to tight. So I figure hmmm... if it's that tight maybe that's not what's making the clunk. Looked around and thought the Rancho bars looked pretty easy to try and remove. Off they came and gone was the clunk sound
Turns out that the bar's rubber bushings need a good lube job before I put them back on
Senior Member
Joined: Feb 2003
Posts: 1,294
Likes: 0
From: Colorado,
You guys are killing me! LOL
At least I have mondays off. Whats your excuse?
Hey Herb are you still making the clunk washer's? I thought you retired from that or sold the buisness.
Smokin that stuff, I bet you could hear the rotors in your S/C turning in slow motion
Senior Member
Joined: Dec 2003
Posts: 1,182
Likes: 0
From: Roseville CA
Originally posted by Konig
I just wanna jump in it and roll around ....and laugh.... a lot
I just wanna jump in it and roll around ....and laugh.... a lot
