Well guys I am out of mods with my 03L, the contractor bulding my house is ahead of schedule so I can not spend alot of money on the truck at this point. I was going to get my long tubes and cats but spending the 1k to get them is too much right now.

I purchased the truck on 2/19/2004 and even though I promised my fiancee that I would not mod this truck I cant help myself.

Mods to date :

MGW billet *****
FRPP lowering with 01 leafs and clunk washers.
Defi gauges (boost - fuel press - water temp)
Column pod and pillar
FTVB and 4x4 pan
Bedrug
Predator and custom tune
Air filter kit
Metco idlers
C&L mass pipe
FJO wideband 02 with green display
Metco 6Lb lower interchangeable pulley
NGK tr6's
Magnaflow cat back

I want to add something else but do not want to drop a bunch of coin because the closing on my house is going to be in late July and I need to keep things somewhat calm downed mod wise till after we get that over with.

What mods have you guys done that you enjoyed but where some what economical? Just looking for some ideas

Bob

 

Sylvania Xenarc HID headlights.

Maybe traction bars or something like a moroso transmission pan.

I would would also look at a panhard bar from Ruslow.

 

NAWWZZ dudE!

 

Power:
Driveshaft loop
Ported Upper
Traction bars
E-fan
Heat exchanger
Ported Eaton

Appearance:
Mats
All kinds of bling from Chickenears.
Grille

 

Yes, I have seen documented 13rwhp gains on a dyno from adding a drive shaft loop.

 

Just put a set of TruckNutz on it and enjoy your ride.

 

E-fan, traction bars, and drive shaft loop.

 

It's a no-brainer -- traction bars.

 

Thanks for the suggestions guys.

I will probably leave it alone for now.

Bob

 

Panhard Bar ... ???