Hey i gotta quick boost actuator question for you all. I know the correct setting for the actuator is a lil bit off the stop, but my question is, which way is bad? Mine is sitting on the stop, would that b keeping me from boost or make me create it as fast as possible? Im thinkin it just allows me to make boost faster, but i was unsure, the truck has had the engine replaced and i wasnt sure if i needed to adjust it or not. Im only worrieda bout it if im loosing performance.

 

I found this under search,

To adjust to boost actuator loosen the 2 bolts holding it to the blower, raise the actuator up until the lever comes off the stop, then lower the actuator back down until the actuator lever is just touching the stop, tighten the bolts back up, your done