Just installed 4lb lower, filter, flip chip +70 and below 70 degrees, all from JDM. Trans pan and line mod valve to do. Only taken it for a short run, but everything seems to be good.
Is there anything that I should do now that I have these mods-driving wise.
I looked at the sparks, but they look rather trickey to do. Any secrets that I should know about changing these? The truck is an `03 with just 3,000 miles on.

 

I had the same setup you have for a while. The plugs are a BIATCH. Take your time and two hours later youll be done.