That pan is sweet looking gadget
already got one of Gregg's pieces submerged in tranny fluid

Got to hit the post office for some stamps so I can get one of those pimping FT decals for the underside of my hood

 

Anybody with the Moroso tranny pan or similar, install a tans temp sensor? I just recieved the same Moroso pan, and was wondering where the best place to drill a hole/have a nut arc'd on (because there is no hole for hole)
Think I could just drill and tap a hole, apposed to having a nut arc'd on?
John

 

There is a test port on the transmission itself already, the sensor from autometer will thread right in after you remove the plug. I believe it's about 1/2 way up on the drivers side, it shouldn't be too hard to spot.

 

Oh ok, for some reason I was under the impression that the sensor went into the pan. Thanks for reminding/informing me as to where it goes.
John

 

But if I see one on a ricer, someone will have a lot to answer for.

G

 

What's the part #for the Moroso tranny plan!

 

this place has a decent price, and they are 10% off this month

http://shop.store.yahoo.com/hm-performance/trpa.html

 

Thanks! I just ordered it.

I think this combined with the FTVB will make a huge performance in my L considering all the weight I carry in the rear as result of the stereo.

 

So is this a Gregg approved setup? I heard many
different posts about the 4x4 not being a good idea,
and I wondered about this one.....

Thanks,

Cliff

 

Does this pan use a stock gasket or does it have a specific gasket that has to be purchased seperate?

 

It uses the stock gasket.

 

I have no problem with it, I use the FRRP pan myself. It (moroso) is a good looking piece.

G

 

I like my B&M.
I looked at the MOROSO and its a nice pan also.
SEE YA!!!!!!!!!!

 

If anybody is at any of the NMRA events I have stickers also Just come by my pit and ask.-Jeff