Went on over to Speedin Bob's place yesterday and got a few goodies bolted to the truck. Finally put on my LFP traction bars and got the panhard bar up and in place.

The Man's Garage. This garage is SWEET!!!!


Traction bar on:


Panhard in:


I love it when I get new stuff installed!
Thanks for all the help Bob. Now hurry up and buy that new fan and let's have a E-fan day!! lol.

-Kimball

 

 

how much for the panhard bar? where did you buy it? Was it an easy install?

 

I bought the bar used, but I believe it goes for $255 new from Stan aka RUSlow. The install is rather straightforward. It include tilting the bed and using a paper template to drill a hole in the frame. Speedin Bob wrote the instructions for it, so I am sure he made it easier than it may normaly may have been.

get that harness yet?

-Kimball

 

****...just plain ****

I was told by yet another service tech that..

"The GPS system is sold as a package. The package is $1500 inlcuding all wireing. We can not sell the wireing by itself. Try a junk yard."

blah blah blah... but I HAVE found a semi good wire diagram that may allow me to pin-out my own connector. Crossing my fingers...I guess if I cant get it to work I could always put a TV in its place...

 

Kimball,

No problem chief. Glad to help. Take any exit ramps with enthusiasm?

Working on fan issue however I did talk to Mark @ LFP and I'm good to go RE the sway bars.



Bob

 

I enjoyed the 25mph offramp at Shelbyville

-Kimball

 

Sounds like you got a lot done this weekend guys!

 

LOL..........What's next Grey2K3

--Joe

 

I ordering my panhard bar tomorrow before Stan becomes unavailabe for the month....

How big of a difference is it? Wat it instantly noticable? I install a set of the Lower Metco traction bars and LOVE how the rear end tightened up..
Heck - that is how I like her rear ; tight

john