questions about built blocks
Thread Starter
|
Senior Member
Joined: Nov 2002
Posts: 310
Likes: 0
From: houston tx
questions about built blocks
ok heres the deal i have a 00 L with 90mm mas air, chip, air induction. i want to get NOS and pully but i have been reading up and see everybody say be carefull with a stock block. so i was thing about getting a built block. what all do ya'll do to the block. all im looking for is pushing 500 hp and some say a stock block might not hold it well i don't like mights so i was wondering what can i do to my block where it is safe to push 500hp to maybe 600hp and i daily drive it and im hard on the gas a lot of times please help thanks a lot.....chris
Senior Member
Joined: Jun 2001
Posts: 2,516
Likes: 0
From: Bay Area, California
buy a lower end package from one of the tuners. They usually come with pistons, rods, bearings, rings, and some ARP stuff. With that package and a GOOD DYNO TUNE, you can push 550rwhp+ all day every day with no problems.
Senior Member
Joined: Jun 2003
Posts: 1,911
Likes: 0
From: South Florida
Originally posted by macracer18
if i want the stock size pistons is that still gonna be a problem for the NOS and other mods
if i want the stock size pistons is that still gonna be a problem for the NOS and other mods
