Trying to install a set of JLP traction bars. The instructions do not say what hardware goes where So I am thinking that by an elimination process I am supposed to use the old hardware nuts from the stock U Bolts?

However they seem to be to tight, so tight that i can't get the nut more then 2 turns with a 1/2 ratchet.

Anybody that has installed these or JLP himself perhaps can advice me on whats wrong.

I have the L in the garage up on stands as I type this.

Thanks

 

Sorry Hilander, got no answer for you ?

Did you try calling Johnny ?
717 786 4670

If not,
Someone will help you out in a minute I'm sure

 

You should have been sent new nuts for the new U bolts. All new hardware is issued.

 

Thanks guys, this sucks, I got the following hardware

8 x Large washers

4 x Medium washers

15 x Small washers

8 x Large nuts

8 x Small nuts

4 x Large bolts

8 x Small bolts

 

hilander: you should have gotten new u bolts with nuts....give me a call ASAP we'll overnight them to you...My apoligy for this mishap... JL