We @ JLP Will now be offering Ported Intakes for those interested.....

 

 

 

 

here's a *stock* intake.........

 

 

how much $$$???

 

Looks nice! Who did the portwork? Do you have before and after flow numbers? What is the cross-section of the intake runners(before and after)?

 

I would be interested in seeing some before and after dyno numbers and whats a lower like that going to set me back.
Asking with CC in hand

 

Me wants. I dont know if wallet does tho.

 

Looks like a big improvement, would like to se some #'s

 

I'm not trying to rain on your parade or anything, but I seriously doubt that you are going to get the #'s from a mod like this. People just don't change out their intake manifold and then dyno. It is like trying to get #'s from people who have ported heads. You probably won't get any #'s on just ported heads because most people will stick on long tubes, bigger valves, and maybe cams all at the same time.

Just look at the size of the runners before and after and ask yourself how this mod couldn't help. I had mine ported and to match the gasket they had to remove about 1/8th inch material from the edges. In my opinion it is a huge restriction.

 

sweet! now if you could respond to my emails or put your phone back on the hook to let me know wher the hell my traction bars are that i ordered over 2 weeks ago.

 

Hey Leonard......

So all you did was gasket match yours??

Was this when your motor was apart?? What else did you add at the time (pistons/rods/valves??)

--Joe

 

Joe nice sig.

how much performance would you get outa doing the porting?