Hello all I am new to the site and also new to a 2016 f150.

As soon as i got the truck it has been modified. lift and mods done at 300 miles !

5.0l

running sb intake, custom cat back straight pipe with 15" resonator 3" diameter pipe. 4" fabtech lift on 275 65r20s(picture has toyo at 2 35's but i was too tight so i droped it to ones listed)

this is just a start this truck will be severlly put to work! Love to learn more about these trucks any advice is positive in my book. If you are in washington state id love to go on some adventures etc!

 

Welcome to the forum and congratulations on your brand new F-150! That is a truck to be proud of, for sure. Any plans on what your next mod will be?

 

nice. those aint cheap and then you put more money into it. GJ

 

That is sharp! Welcome to the site.

 

Welcome! Nice truck and nice rig behind it as well.

 

thanks everyone, yes i plan on doing lots of other mods, i buried it in 4 feet of mud the other day and the 4low and locked rear just plowed right through it.

I just loaded 91 octane tunes from 5 star i currently am running the perf/tow tune, i have 92 octane in Washington so running a 93 tune was risky would have to run some race fuel mix to get the numbers right didn't want to do that. I also ordered a set of 1 3/4" Long tubes from ARH they are not that expensive I think it set me back 1200ish and those will get hot temp ceramic coating and exhaust wrap.

I am drawing up the rocker sliders/steps I was going to do the front and rear bumpers if i decide to go that way i like the oem bumpers for now.

I have a build post i will be doing but need to figure out where that goes on the site.

 

That looks pretty sharp and aggressive looking already.