Hey guys I have spend about 5 hours looking into old threads and still confused.... I have a 07 xlt single cab,..I did the flow thru console,..I found a wrecked FX4 on the junk yard and got the dash board and the wiring harness out of it and installed it to my truck..it was a plug and play situation with very little modifications, but I got to the passenger side where you connect the A/C Blower Motor Switch/Resistor...and I couldn't connect that one because the connectors change now my question do I have to change the whole Black box where this connector goes,..or can I make that connector work??

 

Bump!!!

 

any one?? I need help!!