Ok so I installed a Kenwood DDX 418 in my truck and I like it accept for that it doesn’t want to stay calibrated to touch. I have reset the touch calibration a few times now and both times it doesn’t seem to be spot on and I feel like over time it gets worse. I don’t know if it is just me or what, anyone got any ideas?

 

Did you remove the protective film off the screen?

 

haha didnt know there was one ill check it out thanks

 

so there wasnt a protective screen after all so what I did was take the eraser end of a pencil and used the to calibrate the screen and it works great now. Guess I just had fat fingers

 

I had the same problem. The first time I calibrated mine I touched the circles. The next time i touched he furthest in the corner i could and it worked much better. I didnt read the instructions or anything like that, but it worked better for me.