Kenwood 6019 users
Thread Starter
|
Senior Member
Joined: Aug 2005
Posts: 4,813
Likes: 0
From: Aurora Texas
Kenwood 6019 users
Got a quick question
Heard a system today that had too much signal going to the subs.
where in the HU can you control the LPF to the subs or does this unit make you control your LPF at the amp?
Heard a system today that had too much signal going to the subs.
where in the HU can you control the LPF to the subs or does this unit make you control your LPF at the amp?
Thread Starter
|
Senior Member
Joined: Aug 2005
Posts: 4,813
Likes: 0
From: Aurora Texas
Originally Posted by bluesupercrew05
go to setup, then audio, then towards the lower right you will see a box that says sub. The adjustment goes from -50 to +10.
Is this how Kenwood controls the LF signals to the sub amp?
