Is there an A-pillar gauge pod out there for the '02 that will allow the handle to be in tact?

 

No. The only option is to get a single gauge pod and mount it below the handle, and you may even have to modify it to make that work. I have seen one done that way, and will be doing this myself fairly soon, but can tell you that you will have to do away with the handle if you want more than one gauge.

 

Well, all I want is a single boost gauge anyway. What brand of pod did you buy/going to buy? Thanks for the info.

 

I think Paul at REM told me the other day that a two guage pod that would allow you to use the handle was "coming out". I was ready to get in my truck and haul a$$ so it kind of went in one ear and out the other. You might want to give him a call.

 

REM?

 

I bought mine from Jegs for $20. It's the 2 1/16 pod # 105-15304

 

SWEET! Thanks. Much appreciated. Looks like a clean fit. How hard was it to install?

 

It's very easy. This was my third to install

 

Dont be cheap and get the Gauge Pod that replaces the entire A Pillar, not just the screw on..........it will look better in the long run.

 

Well if there is a gauge pod that allows me to keep the handle then I will go that direction. Do you know of a manufacturer of such a gauge pod?

 

You can keep the Handle with this one. Just mount the pod under the Handle. I dont have a good pic of the pod with the handle installed. I'll try to get one later today.

 

here's mysteryfan's double gauge pod WITH the handle....
(i think he just put a little notch in the one end for the handle, but not sure)

 

Here ya go