Anyone have a problem programming a personal code into the keyless entry system? The factory code works fine, but it will not accept a personal code. I followed the instructions in the owner's manual.

 

I assume that you are aware that nothing will erase the original five-digit code. That code will always activate the system. In effect, you are putting in a supplemental code.

My memory says:

1. Key in the original five-digit code;

2. Within five seconds, press the [1|2] button;

3. Within five seconds, key in your desired five-digit code.

The system will now recognize two codes.

To erase the supplemental code, repeat steps 1 and 2, then perform step 3 using the original code.

Good luck!

 

Here's the dumb question of the day about this topic!

What happens when the original code is not known?
Is there a way to enter a new code without it?
I bought a used truck and dealer didnt know the code..

** i can see tomatoes flying my way for asking dumb q's!**

 

you have to have the original code to program a new one. look under the driver side dash to the left,and it is printed right on the keyless module.

 

Thanks for the info!
Had to twist my back in new positions trying to find it but i got it!

 

ttt