Patman's version of the Gotts intake mod
 

http://i21.photobucket.com/albums/b2...d/DSC09474.jpg
http://i21.photobucket.com/albums/b2...d/DSC09475.jpg
http://i21.photobucket.com/albums/b2...d/DSC09476.jpg

traced around the PVC pipe and used a cut off wheel to open the fender up a bit

http://i21.photobucket.com/albums/b2...d/DSC09477.jpg
http://i21.photobucket.com/albums/b2...d/DSC09479.jpg

rubber isolator ring to keep it setup like factory

http://i21.photobucket.com/albums/b2...d/DSC09480.jpg
http://i21.photobucket.com/albums/b2...d/DSC09481.jpg
http://i21.photobucket.com/albums/b2...d/DSC09483.jpg

we also removed the silencer while we had the intake apart
http://i21.photobucket.com/albums/b2...d/DSC09485.jpg

as usual, clean job Pat. you need to visit my truck :D

Nice job Pat! :thumbsup:

Klitch, it might be a little bit of a drive, maybe we could meet halfway :p

thanks Gator :beers:

:lol: alright but you cant just laugh and leave the poor red ford of mine in disarray! :p

nice job pat! very factory like, like intended!

Almost the same thing I did the first time around, expanded the opening, except I didn't install that rubber trim piece. Nice Patrick! Second time, I upgraded to receive a Volant cold air box. = Larger square opening.

Good Job mister :thumbsup:

BTW- I also sanded the lip out of that schedule 40 on one side for smoother transition.

:beers:

Patrick, what's that deal by your hand, - is that for the car starter ? That push-pin thing. Removed mine 3 years ago, -never reinstalled it again. Just curious as to what exactly it does.

Looks good!

not sure what you are talking about :confused:

that is a hood switch for Taylor's alarm, and actually those are taylor's hands :lol:

Great job man. I'm going to end up doing the Gotts/DWV mod soon.

Nice work, Patrick! :beers:

I think jbrew is talking about the pipe where it's not de-burred and the rough cut remains on the ID of the pipe.

didnt think about doing that, we did remove the tabs on the inside of the filter housing that the factory snorkel attached to.

it would be taylor's truck
looks nice pat

Yea, -Stealth got it. Looking inside of the set up after it was roughed in, -mine stepped up into the PVC. I just thinned it out to match the OEM box, - like port/gasket matching in a way lol.

Not sure if your set up does this, -mine did using the 40.


Ok got it. I recall it was connected to one single wire. Damn thing got in the way to much I guess. Still in the drawer, never put it back on.

Oh and yea, I thought you just had tiny hands ;)