Ok, I have a ProComp Stage1 kit, and my rear end is sagging about 1 1/2 inches or so with the stacked blocks..

I'm thinking about throwing a single block, an AAl, or the combo of the two to level it out. Question is, What will that do to my exhaust setup? I really like the level at which the exhaust sits at now (right below the bumper), but will raising the rear end lower the exhaust from the bumper or what?

 

lifting the suspension will not move the exhaust at all, unless doing a body lift

the exhaust is attached to the body so a suspension lift should not move the placement of the tips at all

hope that helps