So I got my exhaust in yesterday, buddy came over, started at about 7:30, and by 10:30-11 and a case of beer later we were done everything, TB spacer, Cold air intake, and Magnaflow cat back duel exhaust.

It's all great except for the drivers side exhaust is on a angle... I was going to bring it to the shop.. (Well I did, put it in the pipe bender, but all I did was put a little dent in the end of it, too used to working with thicker pipe... like 1/4-3/4"..) So any advice? I was going to go to the exhaust shop, see if they could bend it out a bit for me, or I might have to get a new one made...
Suggestions on any way to do it myself? I have access to a welding shop, with enough fab. equipment available.

I'll get pics up once I get this straightened out... looks kinda stupid now.

Other then that, I love they system.. not too loud, but it's got that great throaty rumble...

 

After spending all Mon night trying to align my pipes to no avail, I decided to take the truck by the muffler shop on wed. They took off the last section of tailpipes and cut and welded them so they would be straight and under my bumper. They also welded the tips on as well as mounted new hangers on the rear.

 

congrats on the good install on everything

 

THanks Buddy!

 

Sweet, that looks really good. I'm goona go somewhere today and get a piece bent so it sits straight...
I was also thinking of going to the shop and putting a tack on each of the pieces so they don't rattle loose, or have someone take em.. cause it takes a whole 5secs to undo the clamps