I have a 05 FX4 5.4 F150 and I am in the market for a catback exhaust. I was interested in the following kit from flowmaster

http://www.flowmastermufflers.com/pr...pdfs/17417.pdf

The only problem I am having with the kit is the overall look of it installed. I am a little concerned with the 90deg bend on the driverside pipe near the axle. Too me it looks like you would see this from the rear and it would hang pretty low? Does anyone have any pics of the kit installed and what it looks like from the rear?

Thanks,

mgt92

 

I would NEVER buy an exhaust setup from the place, I got flowmaster orginal 40 with 3.5" by 18" stainless steel tips labor, install all that for 345.

 

I have had both Flowmaster and Magnaflow, Get a Magnaflow system that wount rust out in a year, www.hotexhaust.com cupon code fordtruck8

---> magnaflow pichttps://www.f150online.com/galleries...757&anum=10272


---> Flowmasterhttps://www.f150online.com/galleries...3055&anum=8260

 

Hi thanks for the replies. I only posted the flowmaster website just for the diagram of it. I am going to shop around when i decide what i want.

THanks for the pics as well, any pics from underneath the truck from the rear eye level? Kind of near the axle? That is what I am concerned about.

Thanks,

mgt92

 

I have good pics of the magnaflow in my gallery but not the flowmaster

 

Just put the Magnaflow system, siso, cat back on my 04 lariat. So far, sounds great, and happy with my purchase. Check out the Magnaflow website, good info there.

 

I recommend Magnaflow instead of Flowmaster too. Magnaflow is all stainless,meaning no rust. It might discolor,but you can polish that out. Flowmasters are notorious for rusting out within a year or tow and loss of low end torque.

 

Its actually.... www.hottexhaust.com

Is the code still working?? Don't see where to enter the code...