Turn Signal Mirrors
Thread Starter
|
Junior Member
Joined: Oct 2001
Posts: 5
Likes: 0
From: Mooresville,NC
Turn Signal Mirrors
Has anyone replaced their non- signal mirrors with the ones that have the signals built in behind the glass? Are these a direct swap with necessary plugs already in door or does it take additional wiring?
Senior Member
Joined: Jan 2000
Posts: 133
Likes: 0
From: Tigard, Or, USA
Yes,
Ok, You have on 01' xlt. So you do have the wiring, right up to the plug for the power mirrors in the door. So yes, its a direct swap of the mirror, and routing the wires through the sail, and incorperating them into the plug...very easy. First side you do will take you a good hour, second side, at least half of that.
Ok, You have on 01' xlt. So you do have the wiring, right up to the plug for the power mirrors in the door. So yes, its a direct swap of the mirror, and routing the wires through the sail, and incorperating them into the plug...very easy. First side you do will take you a good hour, second side, at least half of that.
Member
Joined: Mar 2001
Posts: 63
Likes: 0
From: Port Lavaca,Texas
I did this mirror signal change on a 2000 Expedition without the plug and it was a good 6 hours of work. Part of the time increase was taking the upper window trim off and relacing this trim. Part of the time was spent figuring out the wiring colors that the instructions stated you should use but were not in the harness.
