anybody had a power lock switch fail?

Thread Tools
 
Search this Thread
 
Old Feb 25, 2002 | 07:27 AM
  #1  
levi1998's Avatar
Thread Starter
|
Member
Joined: Jan 2002
Posts: 23
Likes: 0
From: VA
Question anybody had a power lock switch fail?

Just wondering if anyone has had any problems with their power lock pushbuttons. The passenger side on my '97 has become flaky. Last week it just stopped working for a day and then was ok. Now its not working again. Would like to know if anyone else has experienced this sort of problem. The power locks work fine from the drivers side button.
thanks,
 
Reply
Old Feb 25, 2002 | 06:21 PM
  #2  
hmustang's Avatar
Senior Member
Joined: May 1999
Posts: 3,188
Likes: 3
From: Kansas side of the greater KC area
no problems out of mine yet sounds like your switch has gotten dirty contacts or has gone bad or has a loose conection to it.
 
Reply
Old Feb 26, 2002 | 02:17 PM
  #3  
busejag's Avatar
Member
Joined: Mar 2001
Posts: 32
Likes: 0
From: Manila, Philippines
They do fail occasionally. Ive had my driver side solenoid replaced because it failed to lock when I hit the remote. 6 months later the passenger side failed to unlock. They were both covered under warranty. I have a 99 S/C XLT. I dont think they cost that much. Saw the bill and it was like 30 bucks each if im not mistaken. Good luck to you....
 
Reply
Old Feb 26, 2002 | 06:59 PM
  #4  
J-150's Avatar
Senior Member
Joined: Mar 2001
Posts: 4,316
Likes: 1
I had the same thing happen. They wouldn't UNlock from either side, for about a week. And now no problems at all. I figure its a reprieve before they stop working for good.
 
Reply




All times are GMT -4. The time now is 01:58 PM.