Members:

I have enjoyed adding functional lighting mods to my F150 (such as DRL's and aux. back-up lamps).

I was wanting to hear from you members about the "whys & hows" of lighting mods YOU have done.

I'm especially interested in UNDER CHASSIS mods such as "puddle lights", etc., but would like to hear about your addition of: side markers, curb lighting, bed lighting, and any other so called "trick lighting" (including the interior) you may have designed and/or installed.

I already have 10ga., 60A fused, +12v & Gnd. wires strung from front to rear along the frame rail on the left side (during install of aux. back-up lamps) so I'm set for power!

TIA... XLT_D


(No offense, but I'm not interested in: lights behind the grille; lights on grille guards, or other light bars; or illuminated logos.)

>

 

Hi Xltd,

I added a led to the center console between the cup holders, green to match the dash lights. It is not bright just enough lumination to see where to sit a drink at night ran wire under carpet and tapped into light at the dash cupholder got the idea from this site firezapper I believe had posted this mod good luck with your mods
truss

 

Here are my curb side lights.



I have a lot more lights.

Exterior lighting
http://www.f150world.com/firezapper/?album=350

Interior
http://www.f150world.com/firezapper/?album=392

 

I added a round 12v light to my tonneau cover. I put the switch and a 12v power outlet in the bed right above where the bed extender mounts. See the picture (not very clear). The switch is to the left of the outlet. The outlet cover is open.