Hey guys, I just installed some new tail lights on my truck. It's a 1998 flareside. Once I installed them, my cruise control stopped working.(Cruise control was working before installation) Later a buddy of mine was following me at night and said that he could barely tell when I would hit my brakes since the tails were too bright already. Other than that the tail lights work properly, such as no hyperflashing. These are the LED tail lights that I purchased.

http://www.ebay.com/itm/97-03-FORD-F-150-PICKUP-TRUCK-FLARESIDE-BODY-RED-CLEAR-LED-TAIL-BRAKE-LIGHTS-/390609505210?pt=Motors_Car_Truck_Parts_Accessories&hash=item5af2240bba
The package did not come with any instructions, but it did come with a very small amount of information.

Stop/Tail Lamp/Turnsignal:20 LED's
Side Marker Lamp:3 LED's
Backup Lamp: 3156, 12.8v, 32CP

I'm pretty sure I need to install resistors in the tail lights but I don't know which ones. If anyone could help me out or point me in the right direction that would be great! Thanks!

 

somethings screwed up.....the brakes should be brighter than the tails....imo