01 SCREW dash is blacked out

Thread Tools
 
Search this Thread
 
Old Feb 9, 2010 | 07:31 PM
  #1  
lowman4him's Avatar
Thread Starter
|
Junior Member
Joined: Feb 2010
Posts: 3
Likes: 0
01 SCREW dash is blacked out

It started out as an intermittent problem but now the just stay off. The odometer still works though. My dome lights and all exterior lights are working also. I am thinking it might be in the light switch dial. The dimmer is working to turn on the interior lights and dims the dash whenever it does light up. Any other ideas on what it could be? If it is the switch, do I have to replace the whole switch and dimmer or can I just replace the switch?

Thanks
 
Reply
Old Feb 9, 2010 | 07:48 PM
  #2  
SSCULLY's Avatar
Technical Article Contributor
Joined: Jun 2002
Posts: 10,511
Likes: 10
From: Under the flightpath of old ORD 22R
Did you check the fuse for them ?
 
Reply
Old Feb 12, 2010 | 10:10 PM
  #3  
lowman4him's Avatar
Thread Starter
|
Junior Member
Joined: Feb 2010
Posts: 3
Likes: 0
yes, the fuses are ok. There have been times they have come on and even stayed on for a couple of weeks before blacking out again.
 
Reply
Old Feb 13, 2010 | 06:57 AM
  #4  
SSCULLY's Avatar
Technical Article Contributor
Joined: Jun 2002
Posts: 10,511
Likes: 10
From: Under the flightpath of old ORD 22R
Testing the interior lamp section of the switch is the next thing to try

 
Reply
Old Feb 15, 2010 | 10:43 PM
  #5  
lowman4him's Avatar
Thread Starter
|
Junior Member
Joined: Feb 2010
Posts: 3
Likes: 0
I will look at this. I just want to make sure I am being clear on what is not working. The headlights, all inside dome and reading lights are working. I is just the Dash lights that are not working.

Thanks
 
Reply
Old Feb 16, 2010 | 06:55 AM
  #6  
SSCULLY's Avatar
Technical Article Contributor
Joined: Jun 2002
Posts: 10,511
Likes: 10
From: Under the flightpath of old ORD 22R
That is what I understood, but I posted the wrong diagram.



The test for them is to jumper around the panel dimmer switch.

The back of the headlamp switch, jumper the dark blue w/ white wire to the Light Blue w/ red stripe wire.

Thanks for checking on the procedure to use, that was the interior lamp diagram, which you already know works.
 
Reply




All times are GMT -4. The time now is 10:25 AM.