I have an 01 supercrew f150 i just installed a set of King Ranche Power and heated seats in. However i do not have the wiring harness for them. I was wondering which wires on the bottom of the seat control the heater and which ones control the seat motor. The wire color are green, red, orange, and white...the main colors of the wire. Anyone know which wire goes to which. Ive searched alot and couldnt find anything conclusive thanks in advance
Jameson

 

Your GEM may not be setup for heated seats. Do a search on GEM control functions.

 

I searched but didnt find anything talking about GEM anyways my truck has all the fuses for the power seats the one under the hood and the one under the dash it just doesnt have the factory harness going to the seats....strange. Anyways i think the orange wire is the ground, green wire is the 30amp batt constant for the power seats, white whit light blue 10amp is the ignition power source to tell the heated seats to shut off when the vehicle does, and im thinking that the remaining red wire is another power source for the heated seats 30 amps...Anyone correct me if im wrong please ?
im basically stuck wondering what the red wire is for on the seat harness

 

This thread might help you.

 

This is the wiring for the connector to the heated seat :
Brown w/ light blue stripe : Seat Heating Sensor
Dark Green w/ Violet Stripe : Switch to module - Cushion Enable
Yellow w/ light blue stripe : Seat heating element
Red w/ Black Stripe : power ( hot at all times )
Violet w/ light blue stripe : seat back heating element
White w/ light blue stripe : Power ( hot in Run position )
Black w/ light blue stripe : seat heating sensor
Black : Ground
Orange : Module to switch