my aftermarket projectors went and fogged up on one side. slightly irritating to call one headlight "fog eye" just to keep from being overly irritated with it.

has anyone had this problem? anyone succeed in pulling one of these apart without breaking up the housing?

or any miracle way to clean it up?

 

My freind had that problem once which pretty much means that those lights were not properly sealed. I dont see any other way around it and your best shot is to heat em up, clean em up, and seal em up properly.

 

so you think oven idea and pop em apart? any temp range to work in? i tried a blow drier and succeeded in knocking a chip off the outside of the housing so i put it back in the truck lol.