Truck dead in the water
Thread Starter
|
Senior Member
Joined: Sep 2004
Posts: 228
Likes: 0
From: Hill AFB, UT
Truck dead in the water
Went to take my truck back to stock to update my Edge. Edge read 0 in the top corner, when to turn the key and check gauges comes on and truck doesn't turn over. and on top of that the edge scree just goes blank. any ideas?
Technical Article Contributor
Joined: Apr 2009
Posts: 10,697
Likes: 14
From: In the fast lane from LA to Tokyo...
Check your battery and connections.
If your battery was on its last leg during the programming session that might have cooked it.
Sometimes this just happens...........
Put a battery charger on or get a jump start but unplug the edge before the jump.
Programming sessions are covered in The Stickys at the top of this forum.
If your battery was on its last leg during the programming session that might have cooked it.
Sometimes this just happens...........
Put a battery charger on or get a jump start but unplug the edge before the jump.
Programming sessions are covered in The Stickys at the top of this forum.
Last edited by 88racing; Aug 6, 2010 at 11:32 PM.