Good stuff!
Anybody have any ideas about crevice application on door handles.
This stuff covers very well but there is plenty of caution about over application.

Im tempted to use a small model paint brush but wiping off the excess would be a problem in the cracks.

It looks bad between the handle and the door plate and at the pivot where a pad or q-tip will not reach.

What do/would you do?

 

Try a small foam paint applicator that has a sharp chisel point. Remove with a clean one.

 

I thought about it but didn't think about the follow up with another.
Thanks!

The stuff is amazing. On one truck a 4oz bottle may last a few years.

 

This is exactly how I utilize the product. Like you mentioned, it's a great product and the coverage is great... a little goes a VERY long way.

Hint: never, under any circumstance, use a white-terry towel (rag) to remove this product. I know that's not the OP's question but, I just thought I'd add that tidbit to save someone the hassle. Been there, bought the t-shirt... dumb move on my part -- I did it right before the client picked up their vehicle too)

 

Curious as to what happened?
The white lint stuck to the surface?

 

Cheap-o towels = LOTS of lint. Yep... it got linty as heck and the lint almost seemed as though it was growing out of the handle itself...

 

Thats good to know as I am thinking about maybe doing this to my truck this spring and terry clothes is what I would have used.