Earlier i asked if anyone knew of a Tonneau that would work with a tool box and i had a lot of feedback. Then my problem was that my box was a LOW PROFILE. Well i ended up buying an Access Tonneau and did a little cutting around my handles and it works great. I was not concerned about having to roll back the cover to access my handles as i am not in and out of it daily. Anyway maybe this will help someone down the road witht thew same situation.

 

Looks good !

 

Excellent!

 

I know this thread is old, but I would like to know how much cutting you had to do? What all did you have to cut?

 

Really not much at all. There is a support rail that butts up against the tool box and attaches to each side rail. I had to notch out the rail where my toolbox handles are so i could lift them to open the box. That is the only cutting i had to do.

 

how watertight is it?

 

it is not very water tight at all. I was going just for a look i liked and out of site out of mind attitude. I never have anything in the bed to worry about water or being damp.

 

i appreciate the insight i need something that will keep stuff dry as well.