Bedliners, Caps, Tops & Lids
Sponsored by:
Sponsored by:

Spray on bed liner on front bumper

Old Jul 21, 2007 | 05:57 PM
  #16  
phiire's Avatar
Junior Member
Joined: Jun 2007
Posts: 21
Likes: 0
From: Tucson, AZ
It'd be awsome to get the high traffic areas of the truck done, all the thresholds of the doors and tirewells.
 
Reply
Old Jul 22, 2007 | 06:07 PM
  #17  
tuff150's Avatar
Senior Member
Joined: Jul 2007
Posts: 127
Likes: 0
From: New York
Originally Posted by The_Beast
Check out what I did to my wifes runabout when I was still doing Speedliner, this was nearly 3 years ago and still looks like it did when I pulled it out of the shop. We also did my cousins 74 Bronco in the same color (minus the m's ). Did get a couple of runs on the hatch but I was in a hurry and this is just a runabout car that need a paint job and $250 worth of spray in material was far better than $1100 for a paint job.




that was only 250 in materials?
 
Reply
Old Jul 23, 2007 | 02:35 PM
  #18  
The_Beast's Avatar
Senior Member
Joined: Mar 2007
Posts: 296
Likes: 0
From: Coeburn
Yep only $250 worth of material. I was doing Speedliner at the time and I used 4 gallons (actually 3.5 but I messed up and spilled half of one gallon). There was no labor and that was dealer cost on the materials at the time. If I were to do a truck like the one Truckgasm did I would most likely charge in the $2000 range.
 
Reply
Old Jul 23, 2007 | 03:21 PM
  #19  
TruckGasm's Avatar
Senior Member
Joined: Feb 2004
Posts: 1,745
Likes: 1
From: Texas
Well, OK, I'm going out on a limb here. But, I think it's OK, since it's so obvious.

The colors look neat, but what's up with the drips and runs and uneven texture? Is that supposed to be there?
 
Reply
Old Jul 30, 2007 | 09:58 AM
  #20  
The_Beast's Avatar
Senior Member
Joined: Mar 2007
Posts: 296
Likes: 0
From: Coeburn
Thought I had covered that. Oh well I was in a hurry and had my mix a little thin when I sprayed the rear area, my fault completely. The rest of the car turned out fine I just had a brainfart.
 
Reply


Thread Tools
Search this Thread

All times are GMT -4. The time now is 03:49 PM.