Drop in And Spray in? good idea
Thread Starter
|
Member
Joined: Sep 2003
Posts: 57
Likes: 0
From: Staten Island
Drop in And Spray in? good idea
I have an 02 5.4 FX4 with the factory liner. Its all ready pretty scraped up and i lift it and see the nasty stuff that is accumlating. I just installed a soft tornau, so its more work. but I was thinking about Getting a spray in Liner put it, especially the spot that is not protected by drop ins ( the bottom of the tail gate and the back of the bed that makes that valley when the gate is down ) than dropping my plastic one back in, use it till its dead and take it out to a new Spray in, I just dont want a lot of water and stuff to destroy my bed while Im wearing this one out to replace. Also will they plug all the threaded Holes so I can reinstall the Lower tow Hooks? Any Opinions, suggestions?
Also Im starting a new Project, F-150 Interceptor. Im turning my truck into A police interceptor, Lights siren, badges, Front to back, and when i have the cash the Prochager........Ill get pics posted too. It should come out nice.
Also Im starting a new Project, F-150 Interceptor. Im turning my truck into A police interceptor, Lights siren, badges, Front to back, and when i have the cash the Prochager........Ill get pics posted too. It should come out nice.
Senior Member
Joined: Jan 2002
Posts: 531
Likes: 0
From: Lakewood, CA
man, i gotta see that truck when your done, are you a dare cop? anyway, just dump that plastic liner and get the bed sprayed out after you paint the truck. just tell them not to worry about painting the bed.
Thread Starter
|
Member
Joined: Sep 2003
Posts: 57
Likes: 0
From: Staten Island
Im actually heading to the Airforce in Jan, to become a cop, already hired NYPD, but They will hold for military time. Im trying to go DEA or ATF. Its gonna be nice, Today I bought some Diomend plate. Under the rear Driverside seat Im making a nice rack that will hold two power invertors. Ill get pics up this week.
Im debating whether to do a full paint Job, or a DT with obvious indicators. Im woeking on the switch panel now, and the invertors. Im waiting on a few More parts from Galls. I want to have EVERYTHING on hand because its going to cause me to rip the truck apart.
It should come out really nice.
Im debating whether to do a full paint Job, or a DT with obvious indicators. Im woeking on the switch panel now, and the invertors. Im waiting on a few More parts from Galls. I want to have EVERYTHING on hand because its going to cause me to rip the truck apart.
It should come out really nice.
Last edited by 02F15054; Oct 2, 2003 at 12:18 AM.
Senior Member
Joined: Jan 2002
Posts: 531
Likes: 0
From: Lakewood, CA
Ok, NYPD is good and the Air Force has the best military LE training available and they give the same training to the Navy which advances much faster than the AF. Contact me off list as some of the stuff I have doesn't need to be printed here.
