ok guys,

Those of you with light bars can you please take pictures of how you routed the wiring from the bar into the engine bay?


I have the Randy Ellis Designs Bar and will be running 4 6" KC lights. (2 Driving, 2 Long Range)

I am looking for the cleanest way to get the wiring from the bar to the bumper without seeing a bunch of wires.

The lights each come with a fused and relayed harness that I will be covering with split loom. I would like to secure the bundle as much as possible so I do not have the weight of the wires pulling on the back of the lights which over time could cause them to wear or break.

 

You can drill a hole in the back of the bar and run the wires into and down to one side then drill a hole in the bottom and run the wires out along the bracket into the engine bay. That's what I would do.