Hi Guys,
I'm in the midst of an install. I'm mounting 2 amps and X-overs on the rear cab wall of a '05 scab and have been using advice/photos from this forum as invaluable help. My question, is it OK to run the right front tweet & mid speaker wires in the passenger-side door sill channel? I have 4g power wire and 2 remote turnon wires in this channel, so I was concerned about feedback etc. from the power wires. Since the speaker wires are 'amp'd' they probably aren't subject to external signal like preamp out RCA wires eh? Thanks in advance for the help.

 

Your fine

 

Thanks BarTac1! I don't like bugging the "experts" with questions, but I could find any forum comments on running speaker wires parallel and in the same channel with power wires. Perhaps it was a dumb question, but I appreciate the feedback.

 

HA Only thing Im close to being an expert in is beer drinking and sleeping



Only dumb question is the one not asked. Thats what these forums are here for