I'm looking for an amp that will allow me the following setup:

CH. 1 = 150W@ 4 ohms

CH. 2 = 150W @ 4 ohms

CH. 3 = 300W @ 4 ohms

Any suggestions ?

 

I have located a few that might work. Anyone have any experience with any of these amps?

Eclipse XA500

JBL GTO 755.6

MB Quart PAB5400

Rockford Fosgate POWER 1000

 

so you only need three channels correct? you need a high powered 4 channel amplifier that is bridgeable to 2 or 3 channels. these amps are designed to use say channels 1 and 2 to run your door speakers, then you would bridge channels 3 and 4 together to get the higher power you need for your subwoofer

 

If you are refering to the 25 to life power 1000 it will do tons more than that. My perf cert for mine shows 299 per channel (4 channels bridged to 2) and 701 mono @ 2ohm or 911 @ 1ohm. You should lower the impeadence for your sub with this amp.