2011 Power Door Locks Wiring?
Thread Starter
|
Member
Joined: Dec 2011
Posts: 19
Likes: 0
From: Southeast Ohio
2011 Power Door Locks Wiring?
Im trying to install a Pace Edwards PowerGate (LK370) in my 2011 fx4 Scab.
The instructions say i need to tap into the blue/green and grey/brown wires located in the drivers side kick panel.
I believe these wires are for the rear door locks. My Scab doesnt have rear locks!
Has anyone installed this kit or anything similar on the 2011 Scab or 2 door?
Ive spent hours looking for the right wires. HELP PLEASE!
The instructions say i need to tap into the blue/green and grey/brown wires located in the drivers side kick panel.
I believe these wires are for the rear door locks. My Scab doesnt have rear locks!
Has anyone installed this kit or anything similar on the 2011 Scab or 2 door?
Ive spent hours looking for the right wires. HELP PLEASE!
Thread Starter
|
Member
Joined: Dec 2011
Posts: 19
Likes: 0
From: Southeast Ohio
Found wires for door locks on my 2011 Scab. Wires were located on both driver and passenger kick panels.
Blue/green- unlock
Grey/brown-lock
There were two blue/green wires. I would suggest going through the passenger side firewall or rubber plug in the rocker panel. The grommet on the drivers side firewall was hard to run two cables plus sheilding through.
Blue/green- unlock
Grey/brown-lock
There were two blue/green wires. I would suggest going through the passenger side firewall or rubber plug in the rocker panel. The grommet on the drivers side firewall was hard to run two cables plus sheilding through.