Can anyone tell me the procedure to remove that little cubby hole below the Cup holder/Ashtray in the dash of a 05 SC? It almost looks like it simply pops in and out but I am afraid to get too rough with it until I know for sure

Am installing my Prodigy Brake controller into that little space.

 

If you're talking about the dash without the flow thru console, that piece just pulls straight out. Takes a good tug or 2 the first time.

 

Not sure what a Flow Through console is... but this is a straight XLT dash so I think would be a non flow through?

Here is is with the Prodigy and its mounting pod just sitting in there....



I want to pull it and then drill a hole for the wiring harness to pass through behind it on to the plug in.

 

Just grab that cubby and pull straight out. It's held by a couple clips.

 

Thank you. I shall pull away!!!!