I already have flowmaster duals out the back of my truck but i bent one of the pipes so now just want to dump it. So do you guys think it will hurt anything if i just cut it without putting a turndown in there?

o yea it is a 2004 f150 scab fx4

 

just make sure the exhaust wont be escaping under your cab, otherwise you should be fine

 

make sure it isn't too close to the axle either. if enough of the heat from the exhaust gets to the axle is cooks the fluid. don't ask how i know...

 

ok sounds good this will only be temporary till i get to the shop for them to make turn downs....and it is past the cab but not right at the axle so i should be good