When you look at the list of available updates, they are labeled as "Release" and "Beta". I would not use the "Beta" updates unless you are participating in the beta test program for Edge. It is best to stick with the "Release" versions to avoid any unpleasant surprises (no start) or undocumented features (bugs).

 

Here is the new update v18a released on 06/26. It looks like V18a rev 2 really. 4th gear shudder????
• v18a (06/26/2006)
o Readdress 4th gear shudder.
o Added support for the following calibration families:
�� TEJF4 – 2005 5.4L

 

Some of us have experienced a slight "shudder" while coasting down from highway speed, using the cruise control "coast" button.

Maybe this is finally being addressed.

 

Hopefully they finally fixed the lvl 3 shudder issues.


As always being one of the shudder folks I will apply updates when I get home and test to see if the shudder is fixed. I might test for 100-150 miles before I say anything because last time it seemed fixed for about 100 miles.

 

Well, I took my edge out of my truck after programming my truck to normal. i then went to reprogram my edge with the new update and it said that my system was allready flashed. I guess that would make since since this new software is also a v18a. I guess ill have to wait until the next update. I

 

UPDATE: The shudder is still there and very obvious after only driving 25-30 miles.

 

Is the shudder only with a specific hex number or does it happen with all hex numbers. I havent tried level 3 yet.

 

I believe its HEX code(s) specific, because I don't have a shudder at all.

 

Do you know which hex code has the problem, if not whats your hex code maybe I have the same as you.

 

I've got shudder. I haven't updated to the latest version yet because when I checked sunday night it was still in beta.

RXCM4EA is my hex code.

 

I have the RXCM5P9, curious if anyone has this hex with the shudder.

 

Did you download the v20 beta updates? I was going to email the Edge and see if they wanted me to test it out a little bit for them.

 

No it's not because one of thier three test trucks has my hex code and it doesn't have the shutter.

Yes I've downloaded v20 beta. My hex was different than others from the last time I remember giving out my hex.

 

My hexcode is RXCM5E3 and I have the transmission shudder in O/D. I'll update after the V20 calibration is released. I've talked to Edge about the problems several times and they told me that they haven't had a truck with my hex code to test with and until they do there will be nothing that can be done to address a specific code. I've just learned to live with level 2.

 

I'm running RXCM5E4.