We won't tell anyone.

 

Damn that's nice. Allot better looking than the HD.

 

very clean! Looks Great

 

How much are those Grills? Its the Harley Grill right?
Where did you buy it from?

Thanks

Nice truck btw

 

Nope, thats the "chrome edition" grill. The Harley grill is around $300+ right now.

 

I didn't buy mine.It came on my truck w/ the Roush Champions Edition pkg.

 

Yes, this NOT the HD grille. It is the 'Chrome Edition' grill that is sold by Roush and will hit the market soon @ MSRP of $250.

 

I see that NASSTY has the Ford emblem...does that just stick on?? or is it a whole different grille???

 

It's the same grill.There is a bracket that holds the emblem on.I don't know if the bracket on mine is different than the bracket that holds the emblem on an OEM grill.I've never seen the inside of an OEM grill. My emblem is just a normal 06 emblem.

 

The kit comes with an adapter plate that you remove the grille emblem from your FX4/Lariat grille and put it on the new one and it attatches with those little self threading screw on nuts on the plastic rods that stick through. I think it looks more 'custom' without it. I put it on and thought about it then took it back off. I definitelly need a lower though to complement it. I'm open for suggestions as to a good lower that would match up!

 

I like this lower grille. It looks to be a pretty close match. This one is made by Lund and is called Trenz.



Or the Carriage works lower.......

 

think it looks better with the ford oval on it, but thats just me...

looks a whole lot better than most of the knockoff billet grilles out there

 

The CW lower will be noticably thinner in the rails than the Chrome Ed you just got. I'd say the Trenz or Phat Billet would be your best bet.

As for the Ford logo, I didn't like the OEM one placed back on the CW Grill I have, it looked too large and protruding hence why I got the smaller billet one, I think it gives it a more finished look. Just my opinion.

 

Is the roush grill a replacement or a bolt over? How long for installation,etc.
BTW you have a great looking truck! Thanks

 

Complete replacement, took me about 20 minutes. All you need is a 25 torx and a 10mm deep well socket. Thanks!