I received my lift kit via a frieght company today. I am really excited there are some bigass pieces in there. I got the procomp 6" coil spacer kit. The instructions are kind of messed up and are hard to understand so I am going to need help. I won't be installing it for a while (2 or 3 weeks) I still have to get the rims. Anyone have any tips for me?

 

what rims and tires you going to be running?

 

37X13.50 procomp x-terrains, not sure about the rims still looking.

 

That is alot of rubber to rotate for a 4.6.

 

i am gonna change the gears, edge programmer, u.d. pullies, and efans.

 

i am getting worried if the tire are going to fit or not....

 

i dont wanna be the berrer of bad news.....but...josiah has the fabtech kit with his coilovers cranked up a inch int he front ALOT of trimming (says he needs more) and is running 37's.....and you have the coil spacers....you could prob do 36's....i doubt 37's though

 

well i am gonna have to do what it takes to make those 37's fit. i thought josiah wasnt't able to crank his coilovers due to the spinning collar?

 

37's will fit with minor trimming if you get the rims with a good backspacing spacing. I think around 4.5 should work but could be wronge somebody else might be able to shed a little more light on it.

 

Ayresusn may be right....but josiah has 4.5 backspacing talk to him

 

Isnt the edge for 5.4s? But then again what dose it matter. Its the same pcm

 

SOUTHSIDE has 37's on just a leveling kit....

 

I thought he just put them on to see what they looked like because he got them cheap.

 

true but he said he can drive on them, i would like to think i could too with a 6"

 

.....try....but josiah is pretty stuffed....and hes got 37