i put in a set of headers on my truck this week. i dont have picture yet but i will post them whenever i get time. Does anyone else have headers if so what kind

 

How difficult was the passenger side?

 

jba ceramic..they are at my house now...they were installed on my other truck, now im waiting to put them on my new truck. Josiah, they are a bitch. You have to unbolt all the engine mounts and lift the engine one inch. Even then its a bitch to tighten the one near the back. The directions from jba say cuss...tighten...cuss, etc. Its one of those that if you do, get somebody else to do it unless you are a good mechanic. Install time took 3.5 hours.

 

yeah what he said passenger side was a pain but well worth it. i would pay to have it done again. the sound and power is awsome. right now i am just running open headers and next week i am going to get my hi flow cats and maybe some magnaflow mufflers with electris cut outs.

 

How much did you pay for installation?

 

i got underdrive pulleys, efans and headers done all at the same time....600 bucks. But i also got my tires balanced, realigned, oil change, lubed, fluids, etc. They put quite a few hours in, plus they had never done efans before so that took a little mastery. Im sure i could have done it myself, but it would have taken me a lot longer than that.

 

i did it myself but i had a guy qoute me 200 at the least. which i would have paid. i took me and my buddy about 6 hours to do the whole thing