Heres my problem, I bought these pretty nice wheels not too long ago on ebay and the inside of the rim wouldnt allow me to install them unless I used an adapter to push them out 1 1/4". Even after installing them with the adapters, I couldn't mount them flush against the truck because the studs stuck out past the adapters. My local wheel place offered to drill holes where the factory studs made contact. I did this and now they don't balance without requiring a lot of weights. The weights stack so much that they just fall off. What I mean about the inside of the wheel is that the inside is too small and hits the calipers.

What should I do?

The wheels are 16x10 wrapped in 285/75/16.

 

Get new wheels that were meant for your truck..

 

^x2

 

Yeah I'd put em back on e-bay amd get the right wheels

 

Yea, I wouldn't mess with that. Sounds like they need to go to the scrap yard as they might have been torqued against the caliper, - just once is all it takes. The rim(s) is/are bent now,- I wouldn't want to cause grief for another if there's no correcting them. Sucks, but do the right thing.

 

X's 2

 

Yeah very true... So sad because yet are nice wheels. I'll try and recycle them to get some $$$.