Hey,

I installed Viper alarms professionally for a number years, but haven't done one for a couple of years and I am having a tough time knowing which wires to use of the Remote Start (H3) 10 pin connector and which to connect them to in the ingnition harness.
Can you tell me if I need to wire this differntly or if I don't need to use all of the wires?

H3/1 = Ignition 1
H3/2 = Constant 12 V
H3/3 = Accessory
H3/4 = Starter Car Side
H3/5 = Starter Key Side
H3/6 = Constant 12 V
H3/7 = (Ignition 2 or Accessory 2) not sure
H3/8 = N/A
H3/9 = Constant 12 V or N/A

This Flex Relay is new since the last time I installed Viper.
Thank you!

 

I had to remove your second thread as crossposting or multiple threads on the same subject is not allowed. Thanks
Jim