Nice flares. What kind are they and where did you get them?

 

shoulda known you were a goron fan... Looks good!

 

[QUOTE=sae185628;4970978]Finally got around to painting my bed rails and back window valence



Once I get more paint, the lower front valence will be PTM and also the front window cowl black.[/QUOTE

That looks great! Any close up pics? What did you do for prep?

 

looks beautiful! cleanest truck ive seen!

 

24 baby Thanks!

Thanks Rich! Appreciate it

 

Crappy pic but got my front windows tinted last week.

 

Looks good man! I can't wait to get my front ones done. What percent tint did you go with?

 

20% to kind of match the rear doors. They measured 17%.

 

Hey Jerzey the flares are Stampede Ruff Ryderz. Yes thats how they spell them not me. They are the only company that I could find that makes a pocket style flare for a SCrew. I picked em up on RealTruck.com $350 or so shipped. They are also on AutoAnything.com but it would have taken longer to ship so I went with RealTruck. Thanks for the compliment too. I get people asking me often about them. I've only seen one other SCrew with them on.

 

 

Havent been on this particular site in a while. Since my last post, ive got my 4.56 gears with Detroit True Trac and repainted my toolbox. I also have some E-Fans sitting in my garage with a controller all ready to be installed just have to wait until next week to throw em in. Im pretty pumped!!! Went mudding a few nights ago, finally got the inside clean today, still working on the outside. Heres the pics...




Toolbox

 

[QUOTE=Blue-02-2wd;4974112]I suck at taking pics with my phone, they look real close in the phone, I upload them and seems a mile away. I went over it lightly with gray scotch brite. I scrubbed them down with degreaser and then dawn soap. After it dried, I cleaned the heck out of twice with alcohol. Adhesion promoter next, couple light coats of red primer, color, then clear. I had some gouges here and there in the tailgate piece, I smoothed it down the best I could with 1500 grit before all the cleaning, painting, etc.

 

I finally got around to getting the lower front valence PTM. Although you cannot see it, I did paint the wiper arms and cowling black.




I priced my tires today, but I still haven't decided on a 3in body lift, 4-5inch rough country, or 6 inch zone lift. I don't want it to setup to high. I am wanting to run 305/65/18 BFG KO but don't want to much or to little of a gap.

 

Nice!! The PTM valance on this body style makes a big difference IMO

 

Valance looks great! I'd do a suspension lift... Body lifts scare me