So I'm new to this site hoping to get some answers.
I'm gonna put some 35s on my 2007 f150(hopefully
just a leveling kit and minor trimming). I want to
get some aftermarket wheels but they all have different
off sets than stock. Everyone I have talked to said the a
Lower or negative offset will make rubbing worse. Is there
Any offset that will work or should I just stick with the stock
Wheels?
Hoping to get some great feed back thank you for reading.

 

You have two options. Either stick with the OEM wheels or find a new 8 inch wide wheel with 5.5 inches of backspacing. You'll find that 90% are 9 inches wide with 4.5 or 5 inches of backspacing which will require serious use of a sawsall to fit 35's.

 

If he were to stick with the OEM wheels and go with a 2" level kit - what tire size options would he have?

 

I have an 07 on 35s with a level and rear block. 9.5" wide 5.5" bs aftermarket wheels. . I had to trim some wheel well a front valance. Now no rubbing. I didn't mind trimming at all and you can't tell unless I point it out.