Inspection Issue and code
ok, replaced my dead battery last night and took it in today for an inspection. Because I just replaced the battery it would not pass inspection, tech said to drive it about 50 miles to allow the computer to re-read. As soon as he pulled it out of the bay check engine light came on, P0452. I have this before but always seemed to clear itself. However, because I only have 15 days to get it reinspected for free I need quick help. Thanks in advance guys :beers:
|
P0452 Evaporative Emission Control System Pressure Sensor Low Input
Try a new gas cap. |
And drive it like hell. Unless you want to go through the agonizing drive cycle procedure.
|
Originally Posted by glc
(Post 4720857)
P0452 Evaporative Emission Control System Pressure Sensor Low Input
Try a new gas cap. |
Originally Posted by Toyz
(Post 4720884)
And drive it like hell. Unless you want to go through the agonizing drive cycle procedure.
Could you explain the drive cycle procedure? |
|
|
Originally Posted by acf6401
(Post 4721087)
Thanks Toyz. Based on the instructions I believe my next question may have been answered but I will ask anyway just for verification. Can I simply erase all codes using a code reader, and if by erasing them will I then be able to pass inspection? Thanks again for any input.
|
All times are GMT -4. The time now is 05:43 PM. |
© 2024 MH Sub I, LLC dba Internet Brands