Well I got some of the smaller external parts done last night.

*MOTOR MOUNTS*

Before :



After sandblasting :



After painting with high heat caliper paint epoxy:

 

*ASP water pump pulley*

After sandblasting :



After painting with high heat caliper epoxy :

 

*TRANS - BLOCK SPACER*

Before :



After sandblasting :



After painting with high temp caliper epoxy :

 

HI!... A few more goodies came in today :

ARP HEADSTUDS :





OIL PAN GASKET/CAM SENSOR/CYLINDER HEAD TEMP SENSOR :

 

HI!... Went out to the machine shop this morning to pick up my crank and rods, so I can drop them off at SILVER BULLET to get them cryo-treated. Also had to drop off parts. Anyway, they had my block still in the oven from yesterday when they baked it, to get all the paint/oil/grease off the block. Here's a few pics :

 

HI!... Here's some pics of my factory forged steel crank after it was washed and magnafluxed :





I'll get some more pics of the crank after it comes back from SILVER BULLET from getting cryo-treated.

 

looking nice man!!! u sellin any of ur old parts?? and how much were the foxlake heads?

 

HI!... Got a few other small parts sandblasted over at ROTAN yesterday. Idler and belt tensioner pulleys :

After sandblasting :





After painting with black epoxy caliper paint :

 

 

HI!... I took some pics of the truck after I degreased and power washed it today. Tomorrow it will get black paint and undercoating inside the engine bay :

 

 

looks like a mess of wiring harness's .... fun fun fun

 

HI!... Well yesterday I got some more work done on the truck's engine compartment. Painted and undercoated. :







Just have to clean up the electrical a bit more, like re-tape most of it up and route in spots so you don't see it as much. I totally hate a cluttered up engine compartment. lol!

 

HI!... BBK 75MM TB. I've ported and polished it :

 

^^^^ omg someone stole ur engine!!!^^^ see if ur car insurance will replace that for ya hehe you wish!!